There are two distinct timing programs for LAPACK routines in each data type, one for the linear equation routines and one for the eigensystem routines. The timing program for the linear equation routines is also used to time the BLAS. We encourage you to conduct these timing experiments in REAL and COMPLEX or in DOUBLE PRECISION and COMPLEX*16; it is not necessary to send timing results in all four data types.

Two sets of input files are provided, a small set and a large set.
The small data sets are appropriate for a standard workstation or
other non-vector machine.
The large data sets are appropriate for supercomputers, vector
computers, and high-performance workstations.
We are mainly interested in results from the large data sets, and
it is not necessary to run both the large and small sets.
The values of N in the large data sets are about five times larger
than those in the small data set,
and the large data sets use additional values for parameters such as the
block size NB and the leading array dimension LDA.
Small data sets are indicated by lower case names, such as
`stime.in`, and large data sets are indicated by upper case names,
such as `STIME.in`.
Except as noted, the leading `s' (or `S') in the input file name must be
replaced by `d', `c', or `z' (`D', `C', or `Z') for the other data types.

We encourage you to obtain timing results with the large data sets, as this allows us to compare different machines. If this would take too much time, suggestions for paring back the large data sets are given in the instructions below. We also encourage you to experiment with these timing programs and send us any interesting results, such as results for larger problems or for a wider range of block sizes. The main programs are dimensioned for the large data sets, so the parameters in the main program may have to be reduced in order to run the small data sets on a small machine, or increased to run experiments with larger problems.

The minimum time each subroutine will be timed is set to 0.0 in the large data files and to 0.05 in the small data files, and on many machines this value should be increased. If the timing interval is not long enough, the time for the subroutine after subtracting the overhead may be very small or zero, resulting in megaflop rates that are very large or zero. (To avoid division by zero, the megaflop rate is set to zero if the time is less than or equal to zero.) The minimum time that should be used depends on the machine and the resolution of the clock.

For more information on the timing programs and how to modify the input files, see Section 8.

If you do not wish to run each of the timings individually, you can
go to `LAPACK`, edit the definition `timing` in the file `Makefile` to specify the data types desired, and type `make
timing`. This will compile
and run the timings for the linear equation routines and the eigensystem
routines (see Sections 6.7.1 and 6.7.3).

If you encounter failures in any phase of the timing process, please feel free to contact the authors as directed in Section 6.8.

Please note that the BLAS timing runs will still need to be run as instructed in 6.7.2.